Maxx parts Showroom
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Custom body posts

Go down

Custom body posts Empty Custom body posts

Post by Gman Fri 12 Jun - 1:38

These are some custom body posts that I make with a rubber grommet that fits into the body. They have custom made aluminum perchs and include the proline threaded caps.
The posts are made from  5/16" round nylon  6/6 to fit the ue style towers. They are not a perfect flush fit on the front because of the slant of the towers on the maxx, but I find they go together without a problem. 23.04.201723.04.201715:18:5415:18:55The body holes will need to be reamed out to 27/64" to fit the rubber grommets.
I have found the best way to mount the body to them is like any other post on a maxx. Drill the front holes first, then put the body on and screw on the caps,  THEN mark and drill the rear holes.
45.00 a set shipped.  In stock


Custom body posts Body_p10


I can also make post holders for them for just about any towers. Heres some angled holders for Wheelmans Ti Towers.  7.5 deg. for the front and either straight or 4 deg for the cmaxx rear bulkheads. that will hold the post up straight and allow the proline caps to fit flush with the body.
Custom body posts Angled10

Custom body posts Angled11
Custom body posts Angled12

Gman

Messages : 14
Date d'inscription : 2015-03-06

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum